![]() Install the clutch master cylinder while rotating 1/4 turn counterclockwise. Rotate the clutch master cylinder one 1/4 turn clockwise and remove the cylinder from the vehicle.ġ. Cap the reservoir and hydraulic lines in order to prevent fluid loss and contamination.Ĩ. Disconnect the reservoir line from clutch master cylinder.ħ. Disconnect the clutch damper from the clutch master cylinder.Ħ. Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Service Precautions.ĥ. Place a shop towel under the clutch master cylinder in order to catch any fluid loss. Pull the clutch pedal upward in order to disengage the clutch master cylinder pushrod from the clutch pedal.Ĥ. Remove the clutch pedal retainer from the front of the clutch pedal assembly.Ģ. All attached pictures will correlate with these directions as indicated.ġ. After that, I will provide the directions for bleeding the system. Read through them to confirm you did it correctly. With that, I am going to provide all the steps for replacing the part. I have a feeling you didn't get the push rod properly installed.
0 Comments
Leave a Reply. |